|
PARK AIR has taken the continuous punch concept of the Continuous Peer-Sol and applied it to a single hole punching unit. For use on a moving web, the CP- 3000 can operate at speeds up to 600 cycles per minute. The unit makes use of the same punch components as found on our cross bank units.
For use on the edge of a moving web, the unit is available in four throat depths. The ContinuousPunchette uses a heavy duty repairable cylinder fired directly by a high speed solenoid valve. This heavy walled pneumatic cylinder can be readily rebuilt for years of efficient operation.
The die buttons are high speed steel, heat treated for maximum life. All surfaces of the die are finished to maximum smoothness giving proper fit to the punching assembly and assuring a consistent flow of slugs through the unit. This eliminates the occasional chip hang up caused by improper surface finishes.
The unit works on film thicknesses ranging from the thinnest materials available to a maximum of 12mil. Special die buttons and punches are available for specialty applications with a wide variety of“butterfly” styles for our standard to special ”X” and ”Y” configurations. Hole size changes are easily accomplished with a change of only the ball punch and die button.
For applications where Peer-Sol units are impractical, the CP-3000 offers a solid alternative for venting a moving web. When used with our new style controls, accurate positioning of the hole in register to print or draw length is possible even when used in areas where speed varies.
Sharpening Service: After initial purchase of die buttons, you will never buy another one, with our low cost sharpening service. Send a minimum of 6 die buttons at a time, and sharpened die buttons are shipped to you immediately upon receipt of same.
FEATURES
Operates on a moving web
Up to 600 cycles per minute
1-1/4”, 4”, 8”, and 12” throat depth
Sizes: 1/8”,1/4”, 5/16”, 3/8”, and 7/16”
In stock item
Instant installation
Air powered / electrically activated
TIMING OPTIONS
Universal Pulsar Pak
Solid State Timer with Hi-Load Pak
Hole Control I / Micro-Processor II
Length Sensor Control
Fiber Optic Photo Sensor
|
