|
Park Air’s Modified Continuous Peer-Sol ® CPS-6100 punches a line of holes across a moving web. The CPS-6100 accommodates higher speeds - up to 1200 cycles per minute on a production basis, and effectively cuts most film. It is an air operated, electrically activated unit that requires a 40 millisecond pulse to operate. Each unit comes completely equipped with master filter -regulator,gauge and electric high speed solenoid valve that transmits a signal to activate the cylinders. Hole sizes are 1/8", 1/4", 5/16", 3/8", or 7/16" mounted on 1-1/2" centers across the web. Older CPS-6000 punch banks can be upgraded to accept the new high speed punching unit.
NEW STYLE CONTROL UNITS
The CPS-6100 is capable of operating at faster speeds allowing use of our latest hole control systems. Using fiber optics, we are able to punch holes in relation to printing. With our Combination Systems, we can offer units able to punch patterns in registration, independent of changes in film speed.
SHARPENING SERVICE
After initial purchase of die buttons, you will never buy another one, with our low cost sharpening service. Send a minimum of 6 die buttons at a time, and sharpened die buttons are shipped to you immediately upon receipt of same.
MAIN FEATURES
Up to 1200 cycles per minute on a production basis
One or more holes per cycle
Instant installation
Air powered/electrically activated
Regulated air pressure
TIMING OPTIONS
Universal Pulsar Pak
Solid State Timer with Hi-Load Pak
Hole Control I/Micro-Processor II
Length Sensor Control
Fiber Optic Photo Sensor
|
